Log in

View Full Version : Measuring differences


Daniel2001
April 1st, 2018, 06:40 PM
I think most of us measure our penis sizes wrong.
I’m 17 and I usually measure at close or just over 7 inches.
But I used a toilet paper roll and placed it all the way over mine, keeping it pressed in and measure from the bottom of the roll to the top of what was sticking out and got 6.75 inches. I think it keeps you from moving the ruler to somewhere to get more length.
Some guys may not fit in one, but you could cut a line up the roll to loosen it, or if you’re shorter than the roll you’d have to cut it shorter some.
Only my head is hard to fit through.
Anyone else willing to try and see what size you get vs what you normally get?
Also, mine is very straight, but I guess this result wouldn’t be accurate if yours curves a lot.

jamie_n5
April 1st, 2018, 07:53 PM
You measure the top side of your penis from the pubic bone out. Mine sticks out of a toilet paper roll too quite a bit and I am 7".

TheMagicPotato
April 1st, 2018, 08:02 PM
The problem with curved dicks is that if you measure from one side... You'll get a different measure than the other side...

I recommend in this case to put the ruler below your rod... and mark right where you think your head ends.

robin246
April 1st, 2018, 09:44 PM
The problem with curved dicks is that if you measure from one side... You'll get a different measure than the other side...

I recommend in this case to put the ruler below your rod... and mark right where you think your head ends.

ive never measured so thats good to know :)

eggs2006
November 19th, 2018, 12:09 AM
I think this is a very good way to measure

Connordude
November 19th, 2018, 01:16 AM
You measure the top side of your penis from the pubic bone out. Mine sticks out of a toilet paper roll too quite a bit and I am 7".

Same still 7”

Damn we’re lucky lol

hot lazer
November 20th, 2018, 07:12 PM
Also, you should push down the pubic fat pad and measure from there for an accurate measurement.