Measuring

[lockness]

Hi all,
I am unsure only how to correctly measure penis size and some questions.
So how do you correctly measure the width and girth of your penis?

Flaccid size:
Erect size:
Erect girth:

[Canadian Dream]

You would measure length properly by taking the ruler or measuring tape and placing it on top of your penis. Depending on the person some push the ruler or measuring tape into their pubic bone. Then you measure up to the tip. For width all you'd have to do is to place a ruler at a right angle with your penis on the part that's the largest looking directly at it. For girth normally you need a measuring tape, that you wrap around the biggest part of your penis.

[Danial_Mikhael]

For my lenght penis i am measuring all side so i get
Top side:6.5inch
Penis side:7inch
Bottom side:7.3inch
So 6.5+7+7.3 i will get:21
Then 21÷3 for get a average i get:7 inch
So my penis 7 inch
For girth you need to do same thing
Flaccid: 4
Erect: 7inch
Girth: 4.5-5 inch

[lockness]

For your penis lenth, use a straight ruler and lay it ontop of your penis,lightly push it to your pubes while keeping some pressure on your penis. Mesure where your head stops on the ruler.
To mesure girth, take a tape mesure and wrap it around, make sure there are no air gaps/loose parts and mesure where the ends meet.
Flaccid: N/A
Erect: 5.2 in
Girth: 4.5 in

You would measure length properly by taking the ruler or measuring tape and placing it on top of your penis. Depending on the person some push the ruler or measuring tape into their pubic bone. Then you measure up to the tip. For width all you'd have to do is to place a ruler at a right angle with your penis on the part that's the largest looking directly at it. For girth normally you need a measuring tape, that you wrap around the biggest part of your penis.


So do/most people just place the ruler on your cock or do you push it back as far as it goes?

Anyone want to share there sizes?

[Jsss]

When I measure my penis I get a ruler and put it between my head of my dick and my pubes, so you could try that but you have to get an errection first.
Flaccid size: 10cm
Erect size: 16cm
Erect girth: 10cm

[jamie_n5]

Flaccid size: 3"
Erect size: 6.8"
Erect girth: IDK

[bpk1234]

Flaccid: 3in
Erect: 6in
Erect Girth: 5in

[lockness]

Thanks for eveyones help so far,
Keep them coming